If the size mode is ratio then columns specifies the horizontal size ratio. For more information, please see the Ratio Sizing / Fixed Sizing of PDF417. If size mode is fixed then is specifies the number of horizontal rows to be used when rendering. If the size mode is ratio then rows specifies vertical size ratio. Sets the size calculation mode, supported values are ratio (default) or fixed. Parameters for PDF417 2D Barcodes Parameter Note that model type 2 is the most commonly used and widely supported QR Code type and so recommended. Specify the QR Code model type, supported values are 1 and 2 (default). QR Codes printed with greater error correction will be larger for the same data set. Values may be low/ l, medium/ m, quartile/ q, high/ h. Specify the error correction level when printing QR Code barcodes. Note that 0 is equivalent to 1 (dots), and 3 (dots) is the default if this parameter is not specified. Use 0 to specify minimum(Range: 1 ~ 8 (dots) ( 0.125mm ~ 1mm)). Parameters for QrCode 2D Barcodes Parameter No value required, if this parameter is present then HRI (human readable information) will be printed underneath the barcode. For more information, please see 1D Barcode Sizing. Use 0 to specify the minimum size allowed relative to the standard module size. For more information, please see 1D Barcode Sizing.īarcode wide bar module size, for barcode types that support it. Defaults to 10mm.īarcode module size as dots or mm. Height of the barcode to be printed as printer dots, mm (recommended) or % of width. For more information, please see Supported Barcode Types and Data Limitations. Content may be limited depending on the barcode type. Select the barcode type, please see full list of supported types below.ĭata to be encoded in the printed barcode. Of these, the type and data parameters are required for all barcode types. Several parameters can be provided to determine the type and look of the barcode being output. So the command sequence and are equivalent. It is acceptable to use the abbreviation bc instead of the full command name barcode. Output common 1D and 2D type barcode to the document.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |